Checkline DTX2 User Manual download pdf (Page 7)

page 7page 10

4. External Switch Display Freeze

By connecting #10 and #12

of the communications port,

the tester instantaneously

captures the critical reading

and holds the display from

remote locations (use contact

closure and DO NOT apply

voltage across #10 and #12).

5. External Switch Display Clear

By connecting #8 and #12 of the communications port, dis-

play can be cleared from remote locations (use contact clo-

sure and DO NOT apply voltage across).

(1) Pay extra attention to avoid overload as display

value will not change during display hold.

(2) Use contact closure only and DO NOT apply

voltage across #10 and #12 port pins.

Use contact closure only and DO NOT apply voltage

across #8 and #12 port pins.

2. Mitutoyo Digimatic Signal

Connect the CB-304 cable to the communications port and

the device receiving the data. Set up parameters as instructed

from the Mitutoyo processor manual.

3. ±2 VDC Analog Signal

Connect the CB-104 analog cable to the communications port

and the device receiving the data.

Downloading Data from Memory

Choose between the following download methods.

Digimatic Data Download from Memory

1. Connect the tester and device receiving data with CB-304 cable.

2. Turn on the tester. Press and for 3 seconds to enter

Power-On programming (CF9 flashes with solid F0).

3. Press to transmit all data.

4. Press again to exit.

RS-232C Data Download from Memory

Connect the tester and device receiving data with a CB-204 cable.

Use the I[CR] ASCII command to transmit data (uppercase ASCII

character format).

Recalling Data from Memory

1. Turn on the tester.

2. Press and for 3 seconds to enter Power-On program-

ming (CF9 flashes with solid F0). Press and the display

cycles memory location and value. Press to increase loca-

tion and to decrease. Press to exit.

Clearing Data from Memory

1. Turn off the tester.

2. Press again while holding to enter memory mode.

Single Memory Clear

A memory location with a dot at both ends is the last stored value

and the only one that can be erased. Press to erase and ErASEd

is displayed. If you erase any other location Error is displayed.

All Memory Clear

While a memory location or value is displayed, press for 3

seconds, all data is erased, ErASEd is displayed, then – – – – – and

flashing CF9 with solid End. Press to exit. (See page 14-15).

1 2 3 4 5 6 7 8

Comments to this Manuals

No comments

Checkline DTX2 User Manual Page 7

Comments to this Manuals

Related products and manuals for Measuring instruments Checkline DTX2